62
Then turn the handlebars back to the riding posi-
tion (2). The bolt must be re-latched (3).
Completely close the quick-release lever (4).
To check the correct position of the handlebars,
rest your entire body weight on the handlebars
with your hands. The Speedlifter is working cor-
rectly if the handlebars cannot be pushed down
with the quick-release lever closed. If they do
move, you will have to adjust the lever tension.
Open the quick-release lever. Turn the knurled
nut slightly clockwise and close the lever ful-
ly again. Check the stability of the handlebars.
Repeat the process if they still move. If you can
no longer full close the lever, you will have to un-
screw the knurled nut slightly.
The Speedlifter quick-release lever must
be completely closed during the ride, just
like any other quick-release fastener. It
3
2
90°
4
must also be ensured that the unlocking
bolt is latched in the front hole. Never ad-
just the handlebars while riding.
Read the instructions of the component
manufacturer and for more information
visit: www.speedlifter.com.
Operating the „All Up 2.0“ stem
(valid for the Upstreet3 and Gotour3 models)
Release the locking lever.
Pull the handlebars up to the stop. Otherwise they
cannot be rotated.
You can now rotate the handlebars to the right.
Lower the handlebars and close the locking lever.
90°
To Next Page
Loading...
