Fox FT2 - Sensor Wiring (4 Wires)

To Next Page

To Previous Page

Model FT2 101364

3.2.6. Sensor Wiring (4 wires)

Note: Sensor terminations are performed at the factory except when Remote Electronics are provided.

Figure 3-7 Sensor Wiring

Page 22 Fox Thermal Instruments, Inc., 399 Reservation Road, Marina, CA 93933

Main Page

Table of Contents3
Introduction5
Scope5
Product Description5
Block Diagram6
Menu Tree7
Analog 4-20 Ma Outputs9
Discrete I/O9
Frequency/Alarm Output9
Local Display Options9
Communication Features9
Dimension Details9
Installation14
Scope14
Insertion Style14
Mounting - Insertion Style14
Installation Depth15
Sensor Orientation15
Flowmeter Placement - Insertion Style17
Flowmeter Placement - Flow Body Style18
Flow Body Orientation19
Start up20
Scope20
Note: All References to Conduit Orientation Are from the Front Panel Perspective20
Wiring20
Power Input Wiring and Grounding21
To 20 Ma Output Wiring22
Frequency/Alarm Output Wiring23
RS485 Wiring24
Remote Switch Wiring25
Sensor Wiring (4 Wires)26
Remote Wiring Installation27
Start up Sequence28
Measurement Mode28
To 20 Ma Outputs28
Frequency/Alarm Output28
Local Display Screens29
Display Screens29
Engineering Screens30
Resetting Total and Elapsed Time31
Alarm Indications31
Programming32
Programming Using the Local Display32
Data Entry Using the Local Display Module32
Entering the Programming Mode33
Analog 4-20 Ma Output33
Frequency Output34
Discrete Input/Output36
RS485 Serial Communication Settings37
Display Setup39
Password40
Units Settings41
Flow Parameters43
Calibration Parameters46
Reset Total and Elapsed Time47
Restore Database47
Reset CRC47
Simulation48
Preventative Maintenance50
Access to Electronics50
Sensor Cleaning50
Broken or Damaged Probe50
Calibration50
Fuse Replacement (Standard and NFP Version)50
Troubleshooting51
Replacements Parts52
Return Procedure53
Warranty54
Glossary of Terms and Abbreviations55
Index56

Fox FT2 - Sensor Wiring (4 Wires)

Table of Contents