101364 Model FT2
CsvSim = 0 V
CHG OK
F1 F2 F3 F4
Enter the value and then press OK (F4).
Note: This value is used to simulate the Current Sense Voltage (CSV) and should be set to zero for
normal mode.
Enable SIM ?
YES NO
F1 F2 F3 F4
Press YES (F1) to start the simulation mode, NO (F4) otherwise.
Upon pressing either key, the program will return to the FLOW PARAMTER 1 menu.
NOTE: Simulation Mode will be cleared if the power is cycled.
Fox Thermal Instruments Inc., 399 Reservation Road, Marina, CA 93933 Page 45
To Next Page
Loading...