Fronius ArcRover 22 - Control and Display Elements; Carriage Connections and Controls

Control and display elements, connections
Carriage
ArcRover 22 carriage
No. Function
(1) Front limit switch
(2) Control panel
- For the complete operation of the carriage.
- For conguring carriage parameters and creating programs.
(3) Permanent magnet control lever ON/OFF
For switching the permanent magnet on and o󰀨 during vertical operation.
(4) Connecting plug for FOU 30, FMSS 50/100, Service
- For connecting the cable to the optional oscillation unit FOU 30.
- For connecting the cable to the optional motor slide FMS 50 or FMS 100. Mo-
tor slide corrects the position of the welding torch.
- Connection for diagnostic and service purposes.
(5) Not used.
(6) Connecting plug for analogue power source control
For connecting the cable to the power source (analogue arc ignition).
(7) Rear limit switch
(1)
(7)
(3) (2)(4)(5)
(6)
WARNING!
Operating the equipment incorrectly can cause serious injury and damage.
Do not use the functions described here until you have fully read and understood the
following documents:
- These Operating Instructions
- All operating instructions for the system components
17