Fronius ArcRover 22 - Welding Mode Operations; Retrieving Job Data; Loading Carriage Programs

► Load the relevant job on the control panel for the power source. More detailed
information on "Job Mode" can be found in the operating instructions for the power
source.
When an analogue power source is being used, the requisite welding parameters must
be set manually on the power source.
Retrieving param-
eter record (JOB)
on the power
source
Loading the
carriage program
Welding mode
O
TEST
O
I
ArcRover 22
Memory 0
CAR
OSC
ACC
000000
Press
Turn
CAR
OSC
Slot 0
CAR
OSC
Slot 0
CAR
OSC
Slot 3
1. Turn welding toggle switch I/0/TEST to "0".
2. Press the menu adjusting dial for 4
seconds, the LOADING/SAVING menu
will open.
IMPORTANT! The most recently used
menu (LOADING or SAVING) will
always be displayed when the menu
is opened. Turn the menu adjustment
dial to the right until the LOADING
menu (folder symbol) is displayed.
3. Press the menu adjusting dial once.
The set value (Slot 0) is highlighted
white and can be changed.
4. Turn the menu adjusting dial and set
the desired program location (e.g. Slot
3).
IMPORTANT! Program 0 is a facto-
ry-set, read-only default program. All
carriage parameters and oscillation
parameters are contained in this pro-
gram.
Press
for 4
seconds
51