Fronius ArcRover 22 - Correcting FMS Offset; End of Welding Conditions

End of welding
Welding stops after the following events:
- After the Total Path has run,
- When the front or back limit switch has started up,
- When the "Start LEFT/0/RIGHT toggle switch is activated on the control panel;
Correcting the
FMS o󰀨set
1. Press the FMS o󰀨set adjusting dial
once; the FMS o󰀨set status indicator
is highlighted (white frame).
CAR
OSC
000
000
Slot 5
CAR
OSC
000
000
Slot 5
Press
Turn
2. Turn the adjusting dial and apply the
desired o󰀨set correction.
CAR
OSC
000
000
Slot 5
Press
3. Press the adjusting dial once; value
takes e󰀨ect and the input is deactivat-
ed.
54