Fronius ArcRover 22 - Saving Welding Programs; Program Saving Procedure

Saving a
program
O
TEST
O
I
ArcRover 22
Memory 0
CAR
OSC
ACC
000000
Press
for 4
seconds
Press
Press
Turn
CAR
OSC
Slot 0
CAR
OSC
Slot 0
CAR
OSC
Slot 3
CAR
OSC
Slot 3
1. Turn welding toggle switch I/0/TEST to "0" position.
2. Press the menu adjusting dial for 4
seconds, the LOADING/SAVING menu
will open.
IMPORTANT! The most recently used
menu (LOADING or SAVING) will
always be displayed when the menu
is opened. Turn the menu adjustment
dial to the left until the SAVING menu
(disk symbol) is displayed.
3. Press the menu adjusting dial once.
The set value (Slot 0) is highlighted
white and can be changed.
4. Turn the menu adjusting dial and set
the desired program location (e.g. Slot
3).
IMPORTANT! Program 0 is a facto-
ry-set, read-only default program. All
carriage parameters and oscillation
parameters are contained in this pro-
gram.
5. Press the menu adjusting dial once;
program is saved and the input is
deactivated.
Slot 0
CAR
OSC
025
025
Press
6. Press the FMS-O󰀨set adjusting dial
once to return to the main menu.
49