Fitting the sec-
ond torch holder
(option)
The second torch holder is attached to the front of the carriage, in front of the control
panel.
1. Loosen and remove the Allen screws
(a, b).
2. Fit the torch holder (c).
3. Insert and tighten the Allen screws (a,
b).
(c)
(a)
(b)
1. Connect the mains cable to the charger.
Charging the
rechargeable
battery pack
2. Insert the Schuko plug into a 230 V
socket.
LED1 lights up red (mains on).
LED1 LED2
IMPORTANT! Recharge the rechargeable
battery pack after every discharge. Do not
wait until the battery pack is completely
discharged before recharging it.
(a)
(b)
35
To Next Page
Loading...
