Disengaging the
carriage
1. Undo the knurled screws (a) on the
clamp.
2. Insert the hosepack (b) as illustrated.
IMPORTANT! Make sure the hosepack
does not become kinked - this can lead
to wirefeed problems.
3. Tighten the knurled screws (a).
(a)
(b)
To attain correct wirefeed, observe the following when laying the hose pack:
Handling the hosepack
- Do not allow the hosepack to become
kinked
- Always lay the hosepack as straight as
possible
NOTE!
Observe the maximum tensile load on the hosepack holder (see the “Technical data”
section). This value must not be exceeded.
► If necessary, suspend the hosepack. The hosepack must not come into contact
with the oor. Use balancers and hosepack holders (e.g. universal hosepack hold-
er).
42
To Next Page
Loading...
