Before positioning the carriage, check the following:
- The surface of the workpiece must be clean (no sand, shavings, etc.)
- The base plate of the carriage must be free of objects which can be attracted by the
magnet
- The rubber elements of the drive wheels must be undamaged and free of swarf
- The guide wheels must be clean, undamaged and free of welding spatter
Checking the
workpiece sur-
face and carriage
1. Place the carriage on the workpiece.
The side guide wheels must be in
contact with the workpiece.
2. If necessary, correct the position of the
guide wheels.
Placing
the carriage
Setting up the carriage
3. Set the permanent magnet control
lever to the "ON" position.
WARNING!
The activated permanent magnet poses a risk of injury.
There is a danger of injury to the ngers when positioning the carriage.
- Only hold the carriage by the handle and not by the base plate.
NOTE!
Detailed informations on „Setting up
the guide rails“ can be found in chapter
„Preparing the carriage“.
39
To Next Page
Loading...
