Fronius ArcRover 22 - Control Panel Functions; Control Panel Overview

Control panel
No. Function
(1) Display
For conguring parameters and creating programs using the menu adjusting dial
(6). The digital display is illuminated.
(2) FMS-O󰀨set adjusting dial
- For correcting the welding torch position when a FMS 50 or FMS 100 motor
slide is installed.
- For returning to the main menu.
(3) Travel speed adjusting dial
Used to adjust the travel speed of the carriage. The currently set travel speed is
shown on the display.
Setting range: 5 - 200 cm/min
(4) Toggle switch Start LEFT/ 0/RIGHT
For starting and stopping the automatic program sequence in the relevant weld-
ing direction.
(5) Welding toggle switch I/0/TEST
For choosing whether to carry out the automatic program sequence with or with-
out welding.
I ... Welding on preselection
0 ... Welding o󰀨 preselection
TEST ... Arc immediately active (arc test)
(6) Adjusting dial menu
- For menu navigation and parameter entry.
- Pressing 2 seconds: for returning to the main menu.
O
TEST
O
I
ArcRover
22
Slot 0
CAR
OSC
000
000
(6)
(1)
(2)
(3)
(4)(5)
ArcRover 22 control panel
19