Welding position and weld seam tracking
Possible welding
positions
The 4-wheel drive and built-in permanent magnet ensure that the carriage adheres to the
workpiece and guarantee the best possible traction. The following welding positions are
possible:
SlopingHorizontal
Outside of container with minimum diameter of
1500 mm
Vertical
IMPORTANT! In vertical operation, the carriage must be secured by a load securing
device with a locking function to prevent it from falling. The load securing device must be
designed for the total weight of the carriage. The manufacturer accepts no liability for any
damage to persons or property resulting from vertical use of the carriage without a load
securing device.
NOTE!
From an angle of 45° upwards, the carriage must be secured by a load securing device
with a locking function to prevent it from falling.
NOTE!
When used on the “outside of a container”, the container must be turned in the oppo-
site direction and at the same speed.
26
To Next Page
Loading...
