Fronius ArcRover 22 - Initiating the Welding Process; Adjusting Travel Speed During Welding

Starting the
welding process
1. Turn welding toggle switch I/0/TEST to "I".
O
TEST
O
I
ArcRover 22
Memory 0
CAR
OSC
ACC
000000
O
TEST
O
I
ArcRover 22
Memory 0
CAR
OSC
ACC
000000
2. Set the "Start LEFT/0/RIGHT" toggle switch to the desired direction -
the welding process starts. To stop the process early, turn the switch
to the "0" position.
IMPORTANT! Never leave the device unattended, especially when it
is moving automatically.
Correcting the
Travel Speed
1. Press speed adjusting dial once;
speed is highlighted (white frame).
2. Turn the adjusting dial and set the
desired speed (e.g. 45 cm/min).
3. Press the adjusting dial once; value
takes e󰀨ect and the input is deactivat-
ed.
CAR
OSC
035
035
Slot 5
Slot 5
CAR
OSC
045
045
Slot 5
CAR
OSC
045
045
Press
Press
Turn
53