Guidance of the
carriage
Guidance on outside vertical surfaceGuidance on inside vertical surface
The adjustable guide wheels on the side of the carriage ensure proper tracking of the
weld seam. They can be positioned on either side of the carriage. For detailed informa-
tion about the correct setting of the guide wheels, see the section "Preparing the car-
riage". The guide wheels can be set to the following positions:
Inside of container with minimum diameter of 500 mm
IMPORTANT! Use of the carriage in the "PE" overhead position is prohibited.
Possible welding
positions
(continued)
NOTE!
When used on the “inside of a contain-
er”, the container must be turned in
the opposite direction and at the same
speed.
27
To Next Page
Loading...
