Fronius ArcRover 22 - Starting Up the Carriage; Checking System Connections; System Component Power-On Sequence

Starting up the carriage
The following activities and work steps apply to the fully installed system. Before start-
up, check all the connections between, and connection sockets of, the following system
components:
- Carriage
- Rechargeable battery pack or control box (external power supply)
- Oscillation unit or motor slide (if used)
- Power source
- Cooling unit
- Gas cylinder
- Wirefeeder
- Welding torch with hosepack
Precise information on the assembly and connection of the system components can be
found in the relevant operating instructions for the system component.
Checking the
connections
IMPORTANT! There are no xed rules for the sequence in which the system compo-
nents are switched on. They can be switched on in any order.
Switch on the main switch on the following system components:
- Control box (mains operation via external power supply instead of battery)
- Carriage control unit
- Power source
The start screen appears and the main menu is opened:
Switching on the
system compo-
nents
CAR
OSC
000
000
Slot 0
WARNING!
Danger of injury from premature arc ignition.
The arc may be ignited accidentally. This can cause serious eye injuries.
- Before switching on the system components, make sure that the
“Start LEFT/0/RIGHT” toggle switch on the carriage control panel is set to the “0”
position.
43