Fronius ArcRover 22 - Performing a Test Run

Loading the
carriage program
(continued)
Carry out a test run to check that all system components work together correctly. This
is performed without an arc and allows the movements during the processes to be
checked.
Performing a
test run
1. Turn welding toggle switch I/0/TEST to "0".
O
TEST
O
I
ArcRover 22
Memory 0
CAR
OSC
ACC
000000
O
TEST
O
I
ArcRover 22
Memory 0
CAR
OSC
ACC
000000
2. Set the "Start LEFT/0/RIGHT" toggle switch to the desired direction -
the test run starts. To stop the process early, turn the switch to the "0"
position.
IMPORTANT! Never leave the carriage unattended, especially when it
is moving automatically.
3. Carry out a visual inspection during the test run.
4. Make any necessary corrections (welding torch position, carriage
direction of travel, speed, oscillation motion, etc.)
Press
CAR
OSC
Slot 3
5. Press the adjusting dial once;
program is loaded and the input is
deactivated.
6. Press the FMS-O󰀨set adjusting dial
once to return to the main menu.
The loaded program is displayed in
the header.
Press
CAR
OSC
000
000
Slot 3
NOTE!
Before commencing work in vertical operation, ensure that the switch lever for the
permanent magnet is turned to “ON”.
52