Preparing the carriage
Mounting and
setting up the
guide rails
1. Use the M6 knurled screw to attach the guide rails to the carriage.
2. Tighten knurled screws by hand rst. Make sure that the guide rails are sat correctly
in the appropriate recess on the carriage frame.
5 - 10 mm
Direction of travel
(a)
(b)
(a)
(b)
3. Undo the knurled screws (a).
4. Extend the guide wheels (b) to the desired length. To ensure that the carriage keeps
to the chosen direction, the extended guide wheels must be extended by 5 - 10 mm
(see diagram).
5. Tighten the knurled screws (a).
31
To Next Page
Loading...
