WARNING!
Danger due to unsuitable batteries being connected to the charger.
Escaping gas, fire or explosion may result in serious injury and damage to prop-
erty.
▶
Never connect a battery to the charger unless it is compatible in terms of its
type, voltage and capacity and corresponds to the charger settings.
The charger is intended for charging lead-acid batteries and NiCd batteries. Set
the charger to the type of battery to be charged:
-
Pb-WET batteries (PzS, GiS, ...):
Venting, closed lead-acid wet batteries with liquid electrolyte.
-
Pb-GEL batteries (PzV, GiV, ...):
Valve-regulated, sealed lead-acid batteries (VRLA) with fixed electrolyte (gel
or non-woven fabric).
-
NiCd batteries:
Closed or sealed NiCd batteries with liquid electrolyte.
-
Pb-CSM-WET batteries (copper strained metal):
Closed lead-acid CSM batteries with liquid electrolyte.
-
Lead crystal batteries:
EVFJ/CNFJ-type lead crystal batteries.
Proper handling of the device is essential for it to function correctly. Never pull
on the cable when handling the device.
Mains connec-
tion
WARNING!
Danger from electrical current.
This may result in serious injuries or death.
▶
Before starting work, switch off all the devices and components involved and
disconnect them from the grid.
▶
Secure all the devices and components involved to prevent unintentional re-
starting.
▶
If required, nothing other than a type B residual current circuit breaker
should ever be used for connecting the device to the mains.
WARNING!
Danger due to incorrect operation and incorrectly performed work.
This may result in serious injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by trained and qualified personnel.
▶
Read and understand this document.
▶
Read and understand all the Operating Instructions for the system compon-
ents, especially the safety rules.
WARNING!
Danger due to faulty or insufficient power supply.
This may result in serious injury and damage to property.
▶
The power supply requirements detailed in "Technical data" must be met.
12
To Next Page
Loading...
Need help?
General
