To resume the charging process:
2
Press the "Pause/Start" key again.
As long as a battery is connected to the charger, only the charging process can
be interrupted and resumed using the "Pause/Start" key. Display modes can be
changed using the "Menu" key as described in the "Display" section, but this is
only possible when no battery is connected to the charger.
Stopping char-
ging
WARNING!
Danger due to ignition of oxyhydrogen caused by sparks generated when the
charging cables are disconnected.
This can result in serious injury and damage to property.
▶
Before disconnecting or unplugging the charging plug, first stop the charging
process by pressing the "Pause/Start" key.
WARNING!
Danger if the plug connection is disconnected during the charging process
This can result in serious injury and damage to property.
▶
Do not disconnect the plug connection during the charging process.
▶
Do not touch live contacts on the charging plug.
NOTE!
Risk of damage to the battery if it is disconnected from the charger before the
charging process is complete.
This may result in damage to the battery.
▶
Only disconnect the battery from the charger when it is fully charged (green
"Battery charged" indicator lights up).
As soon as the battery is fully charged and has cooled down, the following indic-
ators light up:
-
"Battery charged" indicator (green)
-
"Battery cooled down" indicator
(blue)
For an optimal battery life, only dis-
connect the battery from the battery
charger when the blue "Battery cooled
down" indicator is showing in addition
to the green indicator, in accordance
with the explanation below. If several
battery chargers are in use, first dis-
connect the battery which has been
fully charged for the longest (the
coolest).
29
EN
To Next Page
Loading...
Need help?
General
