Safety rules
General The device has been manufactured in line with the state of the art and according
to recognized safety standards. If used incorrectly or misused, however, it can
cause:
-
Serious or fatal injury to the operator or third parties
-
Damage to the device and other material assets belonging to the operating
company
-
Inefficient operation of the device
All persons involved in commissioning, operating, maintaining and servicing the
device must:
-
Be suitably qualified
-
Read and follow these Operating Instructions carefully
The Operating Instructions must always be at hand wherever the device is being
used. In addition to the Operating Instructions, attention must also be paid to
any generally applicable and local regulations regarding accident prevention and
environmental protection.
All safety and danger notices on the device:
-
Must be kept in a legible state
-
Must not be damaged/marked
-
Must not be removed
-
Must not be covered, pasted, or painted over
For the location of the safety and danger notices on the device, refer to the sec-
tion headed "General information" in the Operating Instructions for your device.
Before switching on the device, rectify any faults that could compromise safety.
This is for your personal safety!
Environmental
conditions
Operation or storage of the device outside the stipulated area will be deemed as
not in accordance with the intended purpose. The manufacturer shall not be held
liable for any damage arising from such usage.
For exact information on permitted environmental conditions, please refer to the
"Technical data" section.
Mains connec-
tion
Devices with a higher rating may affect the energy quality of the mains due to
their current consumption.
This may affect device types in terms of:
-
Connection restrictions, requirements regarding permitted mains impedance
*)
-
Requirements with regard to the minimum short-circuit power requirement
*)
*)
at the interface with the public grid
see "Technical data"
In this case, the operating company or the person using the device should check
whether the device may be connected, possibly by discussing the matter with the
energy company where appropriate.
6