8
Use the "Up/Down" keys to set the
length of the charging lead.
9
Confirm with the "Pause/Start"
key.
The charger is configured with the cor-
rect charging lead length as per the or-
der.
An incorrectly set charging lead length
can negatively influence the charging
process.
10
Use the "Up/Down" keys to set the
cross-section of the charging lead.
11
Confirm with the "Pause/Start"
key.
The charger is configured with the cor-
rect charging lead cross-section as per
the order.
An incorrectly set charging lead cross-
section can have a negative influence
on the charging process.
12
If the displayed charging configur-
ation is correct, confirm the char-
ging configuration with the “Pause/
Start” key.
The charger is preconfigured as spe-
cified in the order.
If the charger was ordered without any additional configuration, the following de-
fault settings are used:
-
Type of battery: Pb-wet (for PzS, GiS)
-
Characteristic: 6 - RI
-
Maximum number of cells intended for the charger
-
Charging time: 7 - 8 h
If the configuration does not coincide with the battery used, the parameters
need to be adjusted accordingly.
More information on the charger parameters can be found under "Configuration
mode" in the "Display" chapter.
Charging
WARNING!
Danger due to escaping battery acid or explosion if faulty batteries are charged.
This can result in serious injury and damage to property.
▶
Before charging, ensure that the battery to be charged is fully functional.
26
To Next Page
Loading...
Need help?
General
