Maintenance Before switching on, always check the mains plug and cable as well as charger
leads and charging terminals for any signs of damage.
If the surface of the device housing is dirty, clean with a soft cloth and solvent-
free cleaning agent only.
Maintenance and
repair
Maintenance and repair work must only be carried out by authorised personnel.
Use only original spare and wearing parts (also applies to standard parts). It is
impossible to guarantee that bought-in parts are designed and manufactured to
meet the demands made on them, or that they satisfy safety requirements.
Modifications, installations or conversions are only permitted with the approval
of the manufacturer.
Obligations of
the operating
company
The operating company must only allow persons to work with the device who:
-
Are familiar with the fundamental instructions regarding safety at work and
accident prevention and have been instructed in how to use the device
-
Have read and understood these Operating Instructions, especially the
"Safety rules" section and have confirmed as much with their signatures
-
Are trained to produce the required results.
Checks must be carried out at regular intervals to ensure that operators are
working in a safety-conscious manner.
Safety inspec-
tion
The manufacturer recommends that a safety inspection of the device is per-
formed at least once every 12 months.
The safety inspection may only be performed by an appropriately qualified elec-
trician
-
After any changes have been made
-
After any additional parts are installed, or after any conversions
-
After repair, care and maintenance are carried out
-
At least every twelve months
For safety inspections, follow the appropriate national and international stand-
ards and directives.
Further details on safety inspections can be obtained from your service centre.
They will provide you on request with any documents you may require.
Markings on the
device
Devices with the CE marking satisfy the essential requirements of the applicable
guidelines.
Devices displaying the EAC mark of conformity satisfy the requirements of the
relevant standards in Russia, Belarus, Kazakhstan, Armenia and Kyrgyzstan.
Disposal Do not dispose of the product in domestic waste. Dispose of it according to the
disposal requirements for waste electrical and electronic equipment valid at the
installation site.
9
EN
To Next Page
Loading...
Need help?
General
