Status codes in the event of a fault in the controller
No. Cause / Remedy
(540) Configuration memory chip missing/faulty
(541) No secondary communication
(542) Secondary initialisation failed
(543) Program/memory fault in characteristic control
(544) Program/memory fault in characteristic control
(545) Primary initialisation failed
(546) Update failed
(547) Load/save settings failed
(548) Load/save characteristic settings failed
(549) Charging could not be resumed after a power failure
(550) Time not set
(551) Hardware change detected
(552) Configuration memory chip invalid
(553) Primary update failed
(554) Fault in the master-slave communication
(555) Incorrect device software
(557) Interruption of the InterLock communication
(558) The second device, which is connected via the InterLock option, has an er-
ror
(559) The second device, which is connected via the InterLock option, is incom-
patible with this device
55
EN
To Next Page
Loading...
