PhA (only with MW / TT 2500 / 3000 / 4000 / 5000)
Phase adjustment of the mains connection of two power sources for simultan-
eous AC welding.
Unit -
Setting range 0 - 5
Factory setting 0
IMPORTANT! Before phase adjustment the "ACF" parameter must be set to
"Syn" in the AC/polarity reversal Setup menu.
Phase adjustment takes place as follows:
-
Prepare a test workpiece for several welding trials for simultaneous AC
welding.
-
Adjust the PhA value on a power source to between 0 and 5 until the best
weld result is achieved.
81
EN
To Next Page
Loading...
Need help?
General
