Err | 051
Mains undervoltage: The mains voltage has dropped below the lower
limit of the tolerance range (see section "Technical data")
Check the mains voltage
Cause:
Remedy:
Err | 052
Mains overvoltage: The mains voltage has exceeded the upper limit of
the tolerance range (see section "Technical data")
Check the mains voltage
Cause:
Remedy:
no | IGn
"Ignition time-out" function is active; current did not start flowing
before the length of wire specified in the set-up menu had been fed.
The power source safety cut-out has tripped.
Press the torch trigger repeatedly; clean the workpiece surface; if ne-
cessary, increase the time until the safety cut-out is triggered in the
set-up menu: level 2
Cause:
Remedy:
Err | PE
The earth current watchdog has triggered the safety cut-out of the
power source.
Switch off the power source, wait for 10 seconds and then switch it
on again. If you have tried this several times and the error keeps re-
curring, contact After-Sales Service.
Cause:
Remedy:
Err | IP
Primary overcurrent
Contact After-Sales Service
Cause:
Remedy:
Err | bPS
Fault in power module
Contact After-Sales Service
Cause:
Remedy:
dSP | Axx
Fault in the central control and regulation unit
Contact After-Sales Service
Cause:
Remedy:
dSP | Cxx
Fault in the central control and regulation unit
Contact After-Sales Service
Cause:
Remedy:
dSP | Exx
Fault in the central control and regulation unit
Contact After-Sales Service
Cause:
Remedy:
dSP | Sy
Fault in the central control and regulation unit
Contact After-Sales Service
Cause:
Remedy:
dSP | nSy
Fault in the central control and regulation unit
Contact After-Sales Service
Cause:
Remedy:
no | Arc
Arc break
Press the torch trigger repeatedly; clean the surface of the workpiece
Cause:
Remedy:
91
EN
To Next Page
Loading...
Need help?
General
