3000 CONTROLLER USER GUIDE
5
9. Press to advance. (Default is SINGLE SETPOINT)
NOTE: If multiple setpoint (segmented) cooking is desired, press
MULTIPLE. Then go to MULTIPLE SETPOINT (SEGMENTED) product
setup and follow the instructions.
0:00 OR
PREVIOUSLY
ENTERED TIME
10. Enter or confirm total cook time with numbered keys.
11. Press to advance.
12. Enter cooking temperature.
13. Press to advance.
14. Enter the level of sensitivity, 0-9, for the product. Sensitivity is the
likelihood that the cook time will have to stretch to compensate for
product variation (condition and/or weight).
15. Press to advance.
1 ALARM TIME
(SHAKE TIME)
0:00 OR
PREVIOUSLY
SET TIME
16. Enter time in cook cycle for audible alarm for shaking or stirring (e.g. 30
second SHAKE into a 3 minute COOK would be entered :30). If set to
0:00 skip to FILTER PROMPT.
17. Press to advance.
1 ALARM
NAME(SHAKE
ALARM)
18. Press to scroll to choice of alarm names. (Default is SHAKE).
19. Press to advance.
20. Press . (Default is AUTO) Cancels alarm automatically
after a few seconds.
21. If MANUAL is desired press to scroll to MANUAL (requires user
to turn off alarm).
22. Press to advance.
23. Press to scroll to choice of shake alarm tones. (Default is
SHORT).
24. Press to advance.
25. Enter time in cook cycle for second alarm for shaking or stirring. Leave
at 0:00 if second alarm is not needed.
26. Press to advance.
0 OR
PREVIOUSLY
SET NUMBER
27. Enter number of cooks before a filter prompt. (Default is “0”) so filter
prompting is not associated with number of cook cycles.
28. Press to advance.
0 OR
PREVIOUSLY
SET NUMBER
29. Enter number of seconds after cook starts that heat comes on. Press
to advance. (Default is 5 seconds). O = Off
30. This is the time, in seconds, after cook starts that heat comes on, before
the controller adjusts the heat in response to the temperature. Note:
Instant on time may need to be adjusted for light cooking loads (in whole
minutes).
0:00 OR
PREVIOUSLY
SET TIME
31. Enter time to hold product before discarding (Default is 0 seconds).
- In Standard mode, the timer runs in the background but cancels when
a new cook is started on that product button. Controller can count
down holds from 8 different product buttons at the same time.
- In Lane mode (selected in TECH MODE), the timer counts down in
the display screen but cancels when a new cook is started in that lane.
Controller counts down one hold per cooking lane.
32. Press to advance.
33. Press button to lock in programming choices and continue with
additional product programming (#4 above).
Press 2 times to return to OFF.