Frymaster easyTouch FilterQuick FQG60T - 1.6 Installation, Operating, and Service Personnel

1-3
1.5 Equipment Description
FQG60T FilterQuick™ easyTouch
®
Series gas fryers are energy efficient, tube-style, gas fired
fryers. These models have a built-in filtration system.
FQG60T FilterQuick™ easyTouch
®
Series gas fryers can be configured for natural gas or
propane (LP) gas, as required by the customer.
Each frypot is equipped with a temperature probe for precise temperature control.
All FQG60T FilterQuick™ easyTouch
®
Series gas fryers come standard with electronic ignition
and melt cycle mode. The FQG60T FilterQuick™ easyTouch
®
Series gas fryers are controlled
with an easyTouch
®
FilterQuick™ controller.
All fryers in this series require an external source of AC electrical power. Units can be
configured for voltages ranging from 100 VAC to 240 VAC.
FQG60T FilterQuick™ easyTouch
®
Series gas fryers are shipped completely assembled. All
fryers are shipped with a package of standard accessories. Each fryer is adjusted, tested, and
inspected at the factory before crating for shipment.
1.5.1 Principles of Operation
The incoming gas flows through orifices and is mixed with air in the burners to create the cor-
rect ratio for proper combustion. The mixture is ignited at the front end of each heat tube by
the pilot light. Internal diffusers slow the flame as it goes through the burner tube. This slow,
turbulent flame increases heat transfer to the walls of the tubes to heat the oil more efficient-
ly.
1.6 Installation, Operating, and Service Personnel
Operating information for Frymaster equipment has been prepared for use by qualified and/or
authorized personnel only, as defined in Section 1.7. All installation and service on
Frymaster equipment must be performed by qualified, certified, licensed, and/or
authorized installation or service personnel, as defined in Section 1.7.
1.7 Definitions
QUALIFIED AND/OR AUTHORIZED OPERATING PERSONNEL
Qualified/authorized operating personnel are those who have carefully read the information in
this manual and have familiarized themselves with the equipment functions, or who have had
previous experience with the operation of the equipment covered in this manual.