6-7
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
One vat doesn’t top off.
A. Filter error exists.
B. Service required error exists
C. Solenoid, pump, pin issue, RTD or ATO issue.
A. Clear filter error properly. If problem
persists, call your FAS for assistance.
B. Call your FAS for assistance.
C. Call your FAS for assistance.
Frypots won’t top off.
A. JIB or saddle tank not connected.
B. Saddle tank is blocked.
C. Fryer temperature too low.
D. Oil is too cold.
E. Top oil empty displayed
F. Service required error exists
G. Melting unit switch is off (only on solid
shortening units)
H. Blown fuse.
A. Ensure the JIB or saddle tank hose is
connected.
B. Ensure that the saddle tank opening is
not blocked by debris.
C. Fryer temperature must be at setpoint.
D. Ensure that the oil in the top off reservoir
is above 70°F (21°C).
E. Ensure the top off reservoir is not out of
oil. Replace top off reservoir or fill from
bulk and reset top off system.
If problem persists, call your FAS for
assistance.
F. Call your FAS for assistance.
G. Ensure the switch on the melting unit is in
the ON position.
H. Check the fuse on the left of the ATO box.
If using a solid shortening melting unit,
check the fuse below the melting unit
switch.
6.2.6 Bulk Oil System Problems
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
Frypot won’t fill.
A. Incorrect setup procedure.
B. Quick disconnect is not connected.
C. Dispose valve not completely closed.
D. Bulk oil tank is empty.
E. RTI pump issue.
A. Power cycle fryer by disconnecting and
reconnecting the bulk oil control connector on
rear of fryer.
B. Ensure the bulk quick disconnect is properly
connected.
C. Ensure the dispose valve handle is pushed fully
closed.
D. Call your bulk oil provider.
E. D. Call you FAS for assistance.
Top off reservoir
won’t fill.
A. Incorrect setup procedure.
B. Another function is in process.
C. Dispose valve not completely closed.
D. Bulk oil tank is empty.
E. Solenoid, pump or switch issue.
A. Power cycle fryer by disconnecting and
reconnecting 5-pin bulk oil control power cord
on rear of fryer.
B. If a filtration or any other filter menu function is
in process or FILTER NOW? YES/NO, CONFIRM
YES/NO, or SKIM VAT are displayed, wait until the
process is complete and try again.
C. Ensure the dispose valve handle is pushed fully
closed.
D. Call your bulk oil provider.
E. Call you FAS for assistance.
Top off reservoir or
vat filling slow.
A. Pump or line issues beyond the scope of
operator troubleshooting.
A. Contact your bulk oil provider.
To Next Page
Loading...
