Frymaster easyTouch FilterQuick FQG60T - Clogged Drain Error; Filter Busy; Auto Top off Problems

6-6
the pan has been out for 30 seconds the controller returns to idle
cook mode. Ensure the pan is dry and assembled correctly. Push
the filter pan back into the fryer. Ensure “P” is not displayed on the
controller.
IS VAT FULL?
9. Press the √ (check) button if the vat is full to continue. The
controller returns to idle cook mode. Press X if vat is not full and
the controller advances to
.
SERVICE REQUIRED
10. If a filtration error occurs six consecutive times, the return valve
closes. Press the √ (check) button to silence alarm and continue.
ERROR PUMP NOT FILLING
11. The system detects oil is not returning to the vat and service is
required. Call your FAS.
SYSTEM ERROR FIXED?
12. Press the X button to continue cooking if possible. Call your FAS to
repair and reset the fryer. The error will be re-displaying every 15
minutes until the issue is repaired. Auto filtration and auto top
off are disabled until the fryer is reset.
ENTER CODE 13. FAS tech enters tech code to reset fryer.
FILL VAT FROM DRAIN PAN?
14. Press the √ (check) button to fill the vat from filter pan to
continue. Follow prompts once the vat is full. Press X to skip
filling from drain pan.
REMOVE PAN 15. Remove the filter pan.
IS PAN EMPTY?
16. Press the √ (check) button if the filter pan is empty and continue
to next step. Press X to continue filling the vat. Follow the
prompts once the vat is full.
17. The controller switches off.
6.2.4.2 Clogged Drain Error
The clogged drain error occurs during auto filtration when the oil level sensor detects that oil has not completely
drained from the frypot. This may be due to a clogged drain or an oil sensor failure. Follow the instructions on the
controller display to clear the error.
When this occurs the controller displays CLEAR DRAIN for 15 seconds changing to IS DRAIN CLEAR?.
1. Clear debris from the drain using the fryer’s friend and press the √ button to continue.
2. The controller displays DRAINING. Once the oil level sensor detects the oil has drained, normal auto filtration
operation resumes.
6.2.4.3 Filter Busy
When FILTER BUSY is displayed the filter interface board is waiting on another vat to be filtered or waiting on
another function to finish. Wait 15 minutes to see if problem is corrected. If not, call your local FAS.
6.2.5 Auto Top-Off Problems
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
Frypots top off cold. Incorrect setpoint. Ensure setpoint is correct.