Frymaster easyTouch FilterQuick FQG60T - CHAPTER 4: Filtration Instructions; Introduction

4-1
FQG60T FILTERQUICK
™
easyTouch
®
SERIES GAS FRYER
CHAPTER 4: FILTRATION INSTRUCTIONS
4.1 Introduction
The FQG60T with FilterQuick™ with fingertip filtration system allows the oil in one frypot to be
safely and efficiently filtered while the other frypots in a battery remain in operation.
Section 4.2 covers preparation of the filter system for use. Operation of the system is covered
in Section 4.3.
WARNING
The on-site supervisor is responsible for ensuring that operators are made aware of the
inherent hazards of operating a hot oil filtering system, particularly the aspects of oil
filtration, draining and cleaning procedures.
WARNING
The filter pad or paper MUST be replaced daily or when the sediment level exceeds the
height of the hold down ring.
4.2 Preparing the Filtration System for Use with Filter Paper or Filter Pad
The FQG60T with FilterQuick™ filtration system allows the oil in one frypot to be safely and
efficiently filtered while the other frypots in a battery remain in operation. The FQG60T with
FilterQuick™ filtration system uses a filter paper configuration which includes a crumb tray,
large hold-down ring, and metal filter screen.
1. Pull the filter pan out from the cabinet and
remove the crumb tray, hold-down ring,
filter paper and filter screen (see Figure 1).
Clean all components with a solution of
detergent and hot water then dry
thoroughly.
Disposal instructions are in the FilterQuick
FQ4000
™
Controller Operation Manual.
Figure 1