Fuji Electric Monitouch V9 Series - Page 320

13.2 Temperature Controller/Servo/Inverter Connection 13-33
13.2.3 E5AN/E5EN/E5CN/E5GN
Communication Setting
Editor
Communication setting
(Underlined setting: default)
Temperature Controller
E5CN/E5SAN/E5EN
Communication level setting
(Underlined setting: default)
*1 When writing setting data from the V9, set “ON” for the “communication writing” setting.
E5GN
Communication level setting
(Underlined setting: default)
*1 When writing setting data from the V9, set “ON” for the “communication writing” setting.
Item Setting Remarks
Connection Mode
1:1 / 1:n
/ Multi-link2 / Multi-link2 (Ethernet) /
1:n Multi-link2 (Ethernet)
Signal Level RS-232C / RS-422/485
Baud Rate 4800 / 9600 / 19200 / 38400 / 57600 bps
Data Length 7
/ 8 bits
Stop Bit 1 / 2
bits
Parity None / Odd / Even
Targe t Port No. 0 to 31
Level
Displayed
Character
Setting Data Setting
Communication
level
PSEL Protocol selection CompoWay/F
U-no Communication unit No. 0 to 31
bps Baud rate 4800 / 9600
/ 19200 / 38400 / 57600 bps
LEn Data length 7
/ 8 bits
Sbit Communication stop bit 1 / 2
bits
Prty Parity None / Odd / Even
Adjustment level CMWT
Communication writing
*1
OFF / ON
Level
Displayed
Character
Setting Data Setting
Communication
level
U-no Communication unit No. 0 to 31
bps Baud rate 4800 / 9600 / 19200 bps
LEn Data length 7
/ 8 bits
Sbit Communication stop bit 1 / 2
bits
Prty Parity None / Odd / Even
Adjustment level CMWT
Communication writing
*1
OFF / ON