13-34 13. OMRON
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Indirect Device Memory Designation
For bit designation, an expansion code setting is required.
00H: when designating bit 0 to 15
01H: when designating bit 16 to 31
PLC_CTL
Macro command “PLC_CTL F0 F1 F2”
Return data: Data stored from temperature controller to V series
*1 8000 (HEX): broadcasting
Device Memory TYPE Remarks
C0 (setting area 0) 00H Double-word, read only
C1 (setting area 0) 01H Double-word
C3 (setting area 1) 03H Double-word
15 8 7 0
n + 0 Model (91 to 98) Device type
n + 1 Address No.
n + 2 Expansion code Bit designation
n + 3 00 Station number
Contents F0 F1 (= $u n) F2
Read controller status
1 - 8
(PLC1 - 8)
n Station number
2
n + 1 Command: 0006H
n + 2
Operation status (higher byte)
00: Control in execution
(Operation in progress while the setting area is “0” with no
error occurring)
01: Control not in execution
(Other than above)
Related information (lower byte)
Operation instructions
1 - 8
(PLC1 - 8)
n
Station number
*1
3
n + 1 Command: 0030H
n + 2
Communication writing
0000H: Communication writing OFF (disabled)
0001H: Communication writing ON (enabled)
Control start/stop
0100H: Channel 1 Run
0101H: Channel 1 Stop
Multi-SP
0200H: Target value 1
0201H: Target value 2
0202H: Target value 3
0203H: Target value 4
AT execution/cancel
0300H: Cancel
0301H: Execute
Write mode
0400H: Backup mode
0401H: RAM write mode
0500H: Save RAM data
0600H: Software reset
0700H: Move to set area 1
0800H: Move to protect level
To Next Page
Loading...