Fuji Electric Monitouch V9 Series - Page 333

13-46 13. OMRON
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Address denotations:
Indirect Device Memory Designation
Device Memory TYPE Remarks
-
0000 Control temperature
00H
0001 Measurement temperature Bank No. 0
0002 Operation status Bank No. 0
0003 Output value Bank No. 0
0004 Output value on the cooling side Bank No. 0
0005 Proportional band
0006 Integral time
0007 Derivative time
0008 Control cycle
0009 Control cycle on the cooling side
000A Output operation Bank No. 0
000B HB warning/HS warning effective channel Bank No. 0
000C Alarm status Bank No. 0
000D Warning mode: warning 1 Bank No. 0
000E Warning mode: warning 2 Bank No. 0
000F Temperature at which an alarm occurs:
warning 1
0010 Temperature at which an alarm occurs:
warning 2
0011 Execution memory bank No. Bank No. 0
0012 Adjustment sensitivity
0013 Adjustment sensitivity on the cooling side
0014 Setting unit Bank No. 0
0015 Input offset value
0016 Manual reset value
0017 Current control temperature
0018 Output lower limit value Bank No. 0
0019 Output upper limit value
001A Output lower limit value on the cooling
side
001B Output upper limit value on the cooling
side
001C Limit of output change rate
001D Heater disconnection detection (HB
warning)
001E SSR failure detection (HS warning) Bank No. 0
001F Heater current value Bank No. 0
0020 SSR leakage current value Bank No. 0
0021 Deadband / overlap band Bank No. 0
0022 Cooling coefficient
0023 Fuzzy strength
0024 Fuzzy scale 1
0025 Fuzzy scale 2
Example: xx : yyyyzz
Channel number 0 to 7
Address number
Colon
Bank number 0 to 7
15 8 7 0
n + 0 Model (91 to 98) Device type
n + 1 Address No. (lower) CH No.
n + 2 00 Address No. (higher)
n + 3 Bank No. Bit designation
n + 4 00 Station number