13 Authentication and Accounting Features
388
Authentication and Accounting Features
13
7 Select [Login to Local Accounts], and then select [Save].
For more information, refer to "Login Type" (P.263).
8 Select [Access Control].
9 Select [Service Access].
10 Select [Unlocked] for the required services to permit users unlimited access, and then
select [Save].
11 After you finish settings for each feature, select [Close].
12 To disable button operations on the control panel, select [Device Access] and select
[Locked], and then select [Save] and then [Close].
13 Select [Passcode Entry from Control Panel] under [Passcode Policy].
Select [On] to prompt users to enter their passcode, or select [Off] if the passcode
entry is not required, and then select [Save] and then [Close].
14 Select [Create/View User Accounts].
15 Select a user displayed as [<Available>], and then select [Create/Delete].
16 Enter a User ID and select [Save].
17 Select [Account Limit].
18 Configure the [Account Limit] and [Feature Access] settings for each service, and then
select [Close].
19 If necessary, select a user role and an authorization group for the user under [User
Role] and [Add This User To Authorization Group] respectively, and then select
[Save].
20 Select [Close] repeatedly until the [Tools] screen is displayed.
21 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
• The machine enters the Login mode, and [Login] is displayed at the lower left of the
[Services Home] screen.
• When [Locked (Show Icon)] is selected for a service under [Service Access], [ ] is
displayed on the button of the applicable service on the [Services Home] screen. Also, [ :
Requires Login] is displayed at the lower left of the [Services Home] screen. [ ] and [ :
Requires Login] are not displayed after authentication.
• When [Locked (Hide Icon)] is selected for a service under [Service Access] the applicable
service is not displayed on the [Services Home] screen. The services is displayed after
authentication.
When [Login to Remote Accounts] is Selected
Perform the following procedures to use remote authentication.
1 Press the <Log In/Out> button.
2 Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
To Next Page
Loading...
Need help?
General
