Fuji Xerox ApeosPort-VI C3370 Administrator's Guide

Executing Calibration
119
Maintenance
3
3 Set [Screen Type], [Paper Supply], and [Target].
Note
z
The following describes calibration procedures using Copy Job 2, as an example.
z
For [Paper Supply], select the paper tray in which A4 , A3 , 8.5 x 11" , or 11 x 17" white paper is
loaded.
z
For Target, select from [Copy & Print Jobs], [Copy Jobs Only], [Print Jobs Only], and [None]. When [Copy &
Print] is not selected for [Target], calibration is not valid for the mode not listed in [Target].
4 Select [Start].
Note
z
The message "Outputting the Calibration Chart... - Copy Job 2" appears and the document for calibration
(Calibration Chart) is printed.
5 Align the magenta patch (squares printed at the top and bottom of the Calibration Chart)
of the printed Calibration Chart against the left side of the document glass, and load the
chart facing down on the document glass.
Note
z
Place the Calibration Chart on the document glass.
Magenta

Fuji Xerox ApeosPort-VI C3370 Specifications

General

Print Resolution	1200 x 2400 dpi
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Functions	Print, Copy, Scan, Fax (optional)
Fax Speed	33.6 kbps
Print Speed	33 ppm (black/color)
Connectivity	Ethernet, USB, Wi-Fi
Memory	4 GB
Paper Input Capacity	1, 140 sheets
Paper Output Capacity	250 sheets
Supported Paper Sizes	A3, A4, A5, B4, B5, Legal, Letter, Executive, Folio, Oficio
Duplex Printing	Yes
PDL	PCL6, PostScript 3
Copy Speed	33 ppm (color/black)