Tools
196
Tools
5
LPD
îš„ Port Status
Select [Enabled] to use LPD.
îš„ Port Number
Enter a port number for LPD from 1 to 65535.
The default value is 515.
z
Do not use the numbers assigned to the other ports.
îš„ Maximum Number of Sessions
Enter the maximum number of client sessions using LPD. You can enter a number from 1 to
10 in 1 session increments.
The default value is 5.
SMB Client
îš„ Port Status
Select [Enabled] to use SMB when you use the Scan to PC (SMB) service or SMB
authentication service
IPP
îš„ Port Status
Select [Enabled] to use IPP.
Set this when you want to use IPP (Internet Printing Protocol) to print via the Internet.
îš„ Added Port Number
Select [Disabled] when you want to set the machine does not accept IPP from other than
the standard port number, or select [Enabled] when accepts all port numbers.
Enter a port number for IPP other than the standard port number from 1 to 65535.
The default value is 80.
z
Do not use a number that is the same as a port number of another port. However, you can use the same port
number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP, WebDAV, and Web
Services on Devices (WSD)).
z
[Added Port Number] cannot be configured if [Port Status] is set to [Disabled]. To configure [Added Port
Number], enable port status and reboot the machine, and then configure [Added Port Number].
Bonjour
îš„ Port Status
Select [Enabled] to use Bonjour.
z
To print from a printer detected by [Bonjour], the LPD port must be activated in advance.
To Next Page
Loading...
Need help?
General
