Maintenance
92
Maintenance
3
Replacing Staple Cartridge (for Booklet Maker Unit for Finisher-B1)
When the optional Booklet Maker Unit for Finisher-B1 is installed and the staple cartridge
needs to be replaced, a message appears on the touch screen. When this message appears,
load a new staple case into the staple cartridge.
z
The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance. Use only
staple cartridges recommended by Fuji Xerox.
z
When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you replace the waste toner container.
z
When replacing the staple cartridge, press the <Machine Status> button and check the current status for the
staple cartridge even when the control panel is lit.
z
To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating, and open the finisher side cover.
2
Hold the tabs on both sides of the staple cartridge and pull the cartridge out of the finisher.
3
Hold the tabs on both sides of a new staple cartridge, and insert it into the original position
until it clicks.
4
Repeat steps 2 and 3 to replace the other staple cartridge.
To Next Page
Loading...
Need help?
General
