z
The machine supports IEEE802.3az (a compliance standard of wired LAN) which reduces the power
consumption of the Ethernet equipments while suspending data transmission. To use this feature, both of
the equipments need to support IEEE802.3az.
This section describes the installation procedures for the Ethernet interface.
1
Press the power switch to switch off the power.
2
Make sure that the touch screen is blank and the <Power Saver>button does not light up.
3
Open the front cover.
4
Press the main power switch to the [ ] position to switch off the main power.
5
Connect a network cable to the Ethernet interface connector.
z
When the Secondary Ethernet Kit (optional) is not installed
z
When the Secondary Ethernet Kit (optional) is installed.
z
Prepare a network cable suitable for your network connection. When you replace the network cable, contact
our Customer Support Center.
6
Press the main power switch to the [ ｜ ] position to switch on the main power.
7
Close the front cover.
8
Press the power switch to switch on the power.
To Next Page
Loading...
