Error Code
591
Problem Solving
15
033-735
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the error still
is not resolved, contact our Customer Support Center.
033-736
[Cause] The forwarding job was interrupted because the data volume
exceeded the upper limit.
[Remedy] No measure is required.
033-737
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
033-738
[Cause] Received abnormal JBIG data.
[Remedy] No measure is required.
033-740
[Cause] The printing of the received fax document was interrupted.
[Remedy] No measure is required.
033-741
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
033-742
[Cause] An error occurred during fax transmission. This error may occur
if the remaining capacity of the machine's memory is 10% or
less and Manual Send is used.
[Remedy] If this error was caused when using Manual Send, connect the
line after storing the document, and then send. If the error still
is not resolved, delete unnecessary data from the hard disk to
free up disk space, and execute the operation again.
If the error persists, contact our Customer Support Center.
033-743
033-744
033-745
033-746
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. Try again. If
the error still is not resolved, contact our Customer Support
Center.
033-747
[Cause] The job is temporarily suspended.
[Remedy] No measure is required.
033-749
[Cause] The machine will automatically recover and print the document.
[Remedy] No measure is required.
033-750
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. Try again. If
the error still is not resolved, contact our Customer Support
Center.
033-751
[Cause] An activity report output occurred during the printer lockout
duration. Outputting the activity report was suspended because
the machine was in the Sleep mode.
[Remedy] No measure is required because the machine will output the
report after exiting the Sleep mode.
Error Code
Cause and Remedy
To Next Page
Loading...
