ESC/P-K Emulation
663
Appendix
16
Reduce/Enlarge 17
(Variable %/
vertical
magnification
)
Sets the magnification for the vertical or horizontal direction.
[45 to 210](Default:100): 45-210%
z
When a continuous form paper is selected for [Original Size], print result is
identical for [Preset %] and [Fit to Cut Sheet].
18
(Variable %/
horizontal
magnification
)
2 Up mode 21 2Sets whether to print with the 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the other.
[0](Default): Off
[1]: Forward
[2]: Reverse
z
When [Landscape] is selected for [Original Size], print result is identical for
[Forward] and [Reverse].
Output destinatio 9 Sets the output tray for the printouts.
[0](Default):Center Tray or Center Tray - Lower
[1]: Left Top Tray (optional)
[2]: Center Tray - Upper
[80]: Right Middle Tray (optional)
Tray 5
confirmation
67 Prints from Tray 5, after you instruct to print and then operate the machine
to start printing.
[0](Default): Off
[1]: On
Grid lines 22 Sets the method for printing double-byte grid lines. The options are as
follows.
[0](Default): Image
[1]: Font
2 Sided printing 12 Sets the 2 sided printing.
[0](Default): Off
[1]: Head to Head
[2]: Head to Toe
z
When [Postcard] is selected for [Paper Size], [Head to Head] and [Head to Toe]
cannot be selected.
Font 13
(Chinese
character
fonts)
Sets the font for double-byte characters.
[3](Default): ShuSong
[4]: FangSong (optional)
[5]: HeiTi (optional)
[6]: KaiTi (optional)
14
(Alphanumeric
fonts)
Sets the font for single-byte characters.
[0](Default): Roman
[1]: Sanserif
z
Since this feature selects the default value, its setting will not be affected when an
extended command is received.
Setting Item Item Number Value
To Next Page
Loading...
