Appendix
692
Appendix
16
Alphanumeric
fonts
112 Sets the font for single-byte characters.
z
For more information on fonts, refer to "Internal Fonts" (P.648).
[0] (Default) : Stroke
[1] : Roman
[2] : Sans serif
Position
adjustment
113
(Vertical
position
adjustment)
Adjusts the hard clip area vertically or horizontally. You can set from -250
mm to +250 mm in 1 mm increments.
[0] (Default) : Does not move the hard clip area.
[1] - [250] : -250 to -1 mm
[251] - [500] : +1 to +250 mm
z
Data outside the printable area is not printed regardless of the adjustment of the
print position. In addition, data moved outside the printable area as a result of
adjusting the print position is not printed.
114
(Horizontal
position
adjustment)
Number of sets 115 Sets the method for specifying the print sets.
[0] (Default) : Protocol
[1] : Panel
[2] : Command
Print control 150
(HP-GL mode)
Selects a graphics language. This setting affects to IW, OW, and UC of HP-
GL/2 commands.
[0] (Default) : HP-GL
[1] : HP-GL/2
z
To print HP-GL/2 command that does not include BP command, select [HP-GL/2].
To Next Page
Loading...
Need help?
General
