z
For information on restricting domains from which e-mail can be received, refer to "Domain Filtering" (P.226).
îš„ Notes on E-mail Receptions
A large volume of e-mail may not be printed if the memory capacity is insufficient. In this
case, increase the memory size or ask the sender to lower the resolution.
îš„ Notes on E-mail Reception when [Split by Data Size] is specified
When [Split by Data Size] is specified as the e-mail splitting method, even if you receive the
split e-mail, you cannot reconstruct and print it.
îš„ Notes on E-mail Transmission when [Split by Data Size] is specified
When [Split by Data Size] is specified as the e-mail splitting method, split the data so as to
enable e-mail reception with e-mail software corresponding to the Message/Partial content
type.
îš„ Job Counter Report
If you specify multiple different [Pages per Side] settings using the Build Job feature, the
numbers of pages displayed for [2 Pages] and [Greater than 2 Pages Up] displayed on the
Job Counter Report are calculated according to the latest N-up setting you specify.
Example 1:
When you select [2 Pages] for Document 1 (4 pages) and [Off] for Document 2 (2 pages),
both Documents 1 and 2 are set to [Off] and the number of printed pages is calculated as
follows:
z
Total pages: 4
z
2 up: 0
Example 2:
When you select [Off] for Document 1 (4 pages) and [2 Pages] for Document 2 (2 pages),
both Documents 1 and 2 are set to [2 Pages] and the number of printed pages is calculated
as follows:
z
Total pages: 5
z
2 up: 5
On ApeosWare Log Management (sold separately) or ApeosWare Accounting Service (sold
separately), the numbers of pages for 2in1, 4in1, and 8in1 are also calculated in the same
way as described above.
The meter on the [Billing Information] screen calculates the number of printed pages
correctly regardless of the [Pages per Side] setting.
îš„ Folder Passcode
You do not need to specify the passcode of a recipient when sending an IP Fax (SIP) to a
remote folder. Thus, the passcode enclosed in "\" or "/" is not replaced by "*" as with that of
regular faxes.If you select an IP Fax (SIP) by mistake and specify the passcode of a
recipient when you send a fax or an Internet fax, the passcode is displayed on the touch
To Next Page
Loading...
Need help?
General
