Home > Scan > Scan from Your Computer (Windows
®
) > Scan Using Nuance
™
PaperPort
™
14SE or Other
Windows® Applications
Scan Using Nuance
™
PaperPort
™
14SE or Other Windows®
Applications
You can use the Nuance
™
PaperPort
™
14SE application for scanning.
• To install the Nuance
™
PaperPort
™
14SE application, launch the Fuji Xerox installation disc, click Install in
the Additional Software section.
• Nuance
™
PaperPort
™
14SE supports Windows
®
7, Windows
®
8, Windows
®
8.1 and Windows
®
10.
• For detailed instructions on using each application, click the application's Help menu, and then click
Getting Started Guide in the Help ribbon.
The instructions for scanning in these steps are for PaperPort
™
14SE. For other Windows
®
applications,
the steps will be similar. PaperPort
™
14SE supports both TWAIN and Windows Image Acquisition (WIA)
drivers; the TWAIN driver (recommended) is used in these steps.
1. Load your document.
2. Start PaperPort
™
14SE.
Do one of the following:
• Windows
®
7
Using your computer, click
(Start) > All Programs > Nuance PaperPort 14 > PaperPort.
• Windows
®
8
Click
(PaperPort).
• Windows
®
10
Click Nuance PaperPort 14 > PaperPort.
3. Click the Desktop menu, and then click Scan Settings in the Desktop ribbon.
The Scan or Get Photo panel appears on the left side of the screen.
4. From the available Scanners list, select TWAIN: TW-FX DocuPrint XXXXX or TWAIN: TW-FX DocuPrint
XXXXX LAN (where XXXXX is the model name of your machine). To use the Windows Image Acquisition
(WIA) driver, select the Fuji Xerox driver that has "Windows Image Acquisition (WIA)" as the prefix.
5. Select the Display scanner dialog box check box in the Scan or Get Photo panel.
6. Click Scan.
The Scanner Setup dialog box appears.
169
To Next Page
Loading...
Need help?
General
