Home > Fax > Voice Operations and Fax Numbers > Combine Address Book Numbers
Combine Address Book Numbers
Sometimes you may want to choose from several long-distance carriers when you send a fax. Rates may vary
depending on the time and destination. To take advantage of low rates, you can store the access codes of long-
distance carriers and credit card numbers as Address Book numbers.
You can store these long dialling sequences by dividing them and setting them up as separate Address Book
numbers in any combination. You can even include manual dialling using the dial pad.
For example: You might have stored '01632' and '960555' in your machine as shown in the following table.
Applicable Models
'01632' stored in '960555' stored in
DocuPrint M375 z/DocuPrint M375 df Address Book: Fuji Xerox 1 Address Book: Fuji Xerox 2
You can use them both to dial '01632-960555' by using the following procedure.
1. Press [Fax] > [Address Book].
2. Swipe up or down or press a or b to display the number of Fuji Xerox 1.
3. Press the number.
4. Press [Apply].
5. Press [Address Book].
6. Press [OK].
7. Swipe up or down or press a or b to display the number of Fuji Xerox 2.
8. Press the number.
9. Press [Apply].
10. Press [Fax Start].
The machine will dial '01632-960555'.
To temporarily change a number, you can substitute part of the number by pressing it using the LCD. For
example, to change the number to '01632-960556', you could enter the number (Fuji Xerox 1: 01632) using
Address Book, press [Apply], and then press 960556 using the LCD.
If you must wait for another dial tone or signal at any point in the dialling sequence, create a pause in the
number by pressing [Pause].
Related Information
• Voice Operations and Fax Numbers
243
To Next Page
Loading...
Need help?
General
