Home > Scan > Scan Using the Scan Button on Your Fuji Xerox Machine > Scan Photos and Graphics
Scan Photos and Graphics
Send scanned photos or graphics directly to your computer.
Use the Scan button on the machine to make temporary changes to the scan settings. To make permanent
changes, use Fuji Xerox's ControlCenter software.
1. Load your document.
2. Press
[Scan].
3. Swipe left or right to display [to Image].
4. Press
[to Image].
The icon moves to the middle of the touchscreen and is highlighted in blue.
5. Press [to Image].
6. If the machine is connected over the network, swipe up or down or press a or b to display the computer
where you want to send data, and then press the computer name.
If the LCD prompts you to enter a PIN for the computer, enter the four-digit PIN on the LCD, and then press
[OK].
7. Do one of the following:
• To change the scan settings, press [Options], and then go to the next step.
• To use the default scan settings, press [Start].
The machine starts scanning. If you are using the machine's scanner glass, follow the touchscreen
instructions to complete the scanning job.
To change scan settings, a computer with Fuji Xerox's Control Center software installed must be connected
to the machine.
8. To scan both sides of the document (DocuPrint M375 z):
• Press [2-sided Scan], and then select the document type.
88
To Next Page
Loading...
Need help?
General
