To Next Page
R
robertfloresSep 12, 2025
What to do if printer cover is open on FujiFilm 3000?
- EEric GordonSep 12, 2025
If the printer cover of your FujiFilm printer is open, firmly close it.
What to do if printer cover is open on FujiFilm 3000?
If the printer cover of your FujiFilm printer is open, firmly close it.
Why white bubbles appear on the printed surface of FujiFilm Printer?
If white bubbles appear on the printed surface (thermal transfer paper, HDP paper) from your FujiFilm printer, check that the type of paper indicated on the message display matches the type actually being used.
Why the ink sheet has a lot of wrinkles in FujiFilm 3000 Printer?
If the ink sheet (thermal transfer paper, HDP paper) has a lot of wrinkles in it when using your FujiFilm printer, check that the type of paper indicated on the message display matches the type actually being used.
How to remove spots or marks that appear in the margin area of FujiFilm 3000 Printer prints?
If spots or marks appear in the margin area of prints from your FujiFilm printer, clean the thermal heads and the platen glass in the scanner unit.
How to fix paper if it has not been loaded correctly in FujiFilm Printer?
If the paper has not been loaded correctly in your FujiFilm printer, reload the paper roll.
How to fix printed image if it is not aligned properly on FujiFilm Printer?
If your FujiFilm printer's printed image is not aligned properly, check the following: * Ensure that both the scanner and printer covers are closed correctly. * Verify that the paper roll has been installed properly. * Clean the document feed rollers and/or paper feed rollers, if needed.
Why the left side of the printed image does not appear on FujiFilm 3000 Printer?
If the left side of the printed image does not appear on your FujiFilm printer, the printer cover may not be closed properly. Open the cover and reclose it firmly, holding both ends.
How to fix spots that appear periodically on FujiFilm 3000 poster?
If spots appear periodically on posters printed by your FujiFilm printer, check to see if the surface of the platen rubber is clean and clean it if needed.
What to do if FujiFilm Printer scanner does not detect the original?
If the original is not detected by the scanner of your FujiFilm printer within the programmed time, press the start/stop key to revert to the initial screen. Then, reset the original and press the start/stop key again.
Why my FujiFilm 3000 Printer makes a rattling or grating noise?
If your FujiFilm printer makes a rattling or grating noise, or displays a “SHUTTLE ERROR” message, clean the shuttle shaft and remove any packaging material in the shuttle shaft unit.
Lists all items that should be included in the printer package.
Step-by-step guide for connecting the printer to a power source.
Important safety warnings, cautions, and classifications to prevent injury and damage.
Step-by-step instructions for loading paper rolls into the printer.
Instructions for printing standard documents in normal mode.
Instructions for printing photographs with appropriate settings and notes.
Instructions for printing with reversed image orientation and notes on printer behavior.
Lists common error messages and the recommended actions to resolve them.
Addresses common printing problems and provides solutions and references.
Instructions for cleaning printer parts like rollers, shafts, and thermal heads.
Instructions for cleaning scanner components such as the platen glass and rollers.
General