Fujitsu 5900C - fi - Document Scanner User Manual

168
8.1 Scanner Settings
■ Settings
Using the Software Operation Panel, you can configure the following settings for the scanner connected to
the PC.
［Device setting］
Item Explanation Selectable parameter Default
Page counter
(Consumables
counter)
For evaluating the consumable
replacement cycle.
Use this function to reset the counters
after replacing consumables.
Refer to “5.1 Consumables and
Replacement Cycle” on page 116
Pad/Pick roller/Separator Roller/Brake
roller
remaining ink level (only for the
imprinter option)
-
Power saving
setting
Select the waiting time before entering
the Power saving mode.
Refer to “8.2 Power saving setting”
on page 172
Setting range 15 to 55 minutes (set in
steps of 5 min.)
15 min.
Offset setting Adjust the start position for the docu-
ment scanning.
Refer to “8.3 Offset/Scan scale” on
page 173
Left right: setting range -2 to 3mm
(set in 0.5mm steps)
Up down: setting range -2 to 3mm (set
in steps of 0.5mm)
left right
0mm
up down
0mm
Scan scale Adjust the magnification in the feed-
ing direction.
Refer to “8.3 Offset/Scan scale” on
page 173
Setting range -6.3% to 6.3% (set in
0.1% steps)
0%

Fujitsu 5900C - fi - Document Scanner Specifications

General

Brand	Fujitsu
Model	5900C - fi - Document Scanner
Category	Scanner
Language	English