192
8.16 Imprinter Selection
8.16 Imprinter Selection
You can specify which imprinter to use; Pre-imprinter or Post-imprinter, if you already have installed these
options.
Configure the settings for the Imprinter Selection as follows:
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 166.
2. Select the “Imprinter Selection” setting on the [Device Setting 2] tab.
3. Select the Imprinter to use.
Normal (obey Host specification): Complies with the scanner driver setting.
Forcibly select Pre-imprinter: Pre-imprinter is forcibly used to print unless directed by
the scanner driver.
Forcibly select Post-imprinter: Post-imprinter is forcibly used to print unless directed by
the scanner driver.
HINT
For details on the specifications of the imprinter, refer to “9 OPTIONS” on
page 195.
To Next Page
Loading...
