Fujitsu ETERNUS DX100 S3 - Figure 93 Connection Example Without a Dedicated Remote Support Port; Figure 94 Connection Example When the IP Address of the Slave CM Is Set (and a Dedicated Remote Support Port Is Not Used)

■
Connection Configurations
MNT ports are used for connecting a LAN for operation management.
Figure 93 Connection Example without a Dedicated Remote Support Port
Remote support
center
RMT ports are not used.
LAN switch
NTP server
Authentication
server
Syslog server
ETERNUS DX
C
ontroller enclosure
RMT MNT
CM#0
RMT
CM#1
IP address A
MNT
Administration
terminal
SNMP
manager
E-mail server
LAN for operation management
The following figure provides connection examples for when setting the IP address of the Slave
CM.
Figure 94 Connection Example When the IP Address of the Slave CM Is Set (and a Dedicated Remote
Support Port Is Not Used)
Remote support
center
RMT ports are not used.
The IP addresses of the
Master CM and the Slave CM
are set.
LAN switch
SNMP
manager
NTP server
E-mail server
Authentication
server
Syslog server
LAN for operation management
ETERNUS DX
Controller enclosure
RMT MNT
CM#0
RMT
CM#1
Administration
terminal
IP address BIP address A
MNT
4. Connection Configuration
LAN Connection
157
Fujitsu Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems
Design Guide (Basic)
Copyright 2023 Fujitsu Limited
P3AM-7642-32ENZ0