Fujitsu ETERNUS DX100 S3 - Figure 118 Installation Diagram for 3.5 Drives

■
3.5" Drives
The installation priority order for 3.5" drives is shown below.
1 3.5" SSDs (400GB) (MLC SSDs)
2 3.5" SSDs (400GB) (Value SSDs)
3 3.5" SSDs (800GB)
4 3.5" SSDs (960GB)
5 3.5" SSDs (1.6TB)
6 3.5" SSDs (1.92TB)
7 3.5" SSDs (3.84TB)
8 3.5" self encrypting SSDs (400GB)
9 3.5" self encrypting SSDs (800GB)
10 3.5" self encrypting SSDs (1.6TB)
11 3.5" self encrypting SSDs (1.92TB)
12 3.5" self encrypting SSDs (3.84TB)
13 3.5" Nearline SAS disks (2TB/7.2krpm)
14 3.5" Nearline SAS disks (3TB/7.2krpm)
15 3.5" Nearline SAS disks (4TB/7.2krpm)
16 3.5" Nearline SAS disks (6TB/7.2krpm)
17 3.5" Nearline SAS disks (8TB/7.2krpm)
18 3.5" Nearline SAS disks (10TB/7.2krpm)
19 3.5" Nearline SAS disks (12TB/7.2krpm)
20 3.5" Nearline SAS disks (14TB/7.2krpm)
21 3.5" Nearline SAS self encrypting disks (4TB/7.2krpm)
22 3.5" Nearline SAS self encrypting disks (8TB/7.2krpm)
23 3.5" Nearline SAS self encrypting disks (12TB/7.2krpm)
According to the installation order,
install drives in the slots of a controller enclosure from Slot#0
to Slot#11 in ascending order. Then, install drives in the slots of a drive enclosure from Slot#0 to
Slot#11 in ascending order.
Figure 118 Installation Diagram for 3.5" Drives
Slot#0
S
lot#4
Slot#8
Slot#1
S
lot#5
Slot#9
Slot#2
S
lot#6
Slot#10
Slot#3
S
lot#7
Slot#11
5. Hardware Configurations
Standard Installation Rules
191
Fujitsu Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems
Design Guide (Basic)
Copyright 2023 Fujitsu Limited
P3AM-7642-32ENZ0